Differences

This shows you the differences between two versions of the page.

--- service:wc [2025/11/14 22:04] – [Filler mechanism] daniel
+++ service:wc [2025/11/15 10:20] (current) – [Filler mechanism] daniel
@@ Line 13: / Line 13: @@
 {{:service:wc:img_20251114_145014.jpg?400|}}
-Use a finger to remove the button together with the tube
+Use a finger, unscrew the blue tube to remove the button together with the tube
 {{:service:wc:img_20251114_145037.jpg?400|}}
@@ Line 40: / Line 40: @@
 The filler mechanism is secured to the main mechanism by two plastic clips.
-By carefully using a screwdriver to bend the clips inward and at the same
+Alternative 1: By carefully using a screwdriver to bend the clips inward and at the same
 time lifting the filler mechanism, it can be removed.
 {{:service:wc:img_20251114_145720.jpg?400|}}
+Alternative 2: It should be possible to just pull the handle to remove the filler mechanism.
 {{:service:wc:img_20251114_145744.jpg?400|}}
@@ Line 54: / Line 58: @@
 ===== Repair and assembly =====
-The plunger has its aged and therefore faulty rubber seal mounted in the middle of the plunger. The rubber part at the end is for sealing off the water from the main pipe. Now for the fix. An O-ring fits inside the seal:
+The plunger has its aged and therefore faulty rubber seal mounted in the middle of the plunger. The rubber part at the end is for sealing off the water from the main pipe.
+Now for the fix. An O-ring fits inside the seal:
 {{service:wc:img_20251017_185715.jpg?400|Plunger}}
 By putting four O-rings on the plunger, the original seal gets just big enough to start working as a seal again:
 {{service:wc:img_20251017_190220.jpg?400|O-rings}}
 The suitable O-ring was found to be "R-04" from my [[https://www.clasohlson.com/se/O-ringar,-407-st./p/31-1704|Clas Ohlson O-ring box]]:
 {{service:wc:img_20251017_190236.jpg?400|}}